BRANDS
- 4 SEVENS
- ARMYTEK
- DEREELIGHT
- EAGLETAC
- FENIX
- GLO TOOB
- HDS SYSTEMS
- ITP LIGHT
- ICON
- JETBEAM
- KLARUS
- LED LENSER
- LUMAPOWER
- LUMINTOP
- MAGLITE
- MAXPEDITION
- NITECORE
- OLIGHT
- PELICAN
- PHOTON MICRO
- SUNWAYMAN
- SUREFIRE
- THRUNITE
- WOLF EYES
- ZEBRALIGHT
CATEGORIES
> 4SEVENS > QUARK 123 R5 NO CLIP
4sEVENS qUARK 123 r5 (No Clip)
The 4Sevens Quark 123 R5 clipless version uses a single CR123A battery and has a maximum output of 206 'out the front' lumens.
Featuring five power levels plus strobe and SOS setting.
Includes belt holster, lanyard, finger grip and spare o-rings.
Click here to see the new 4Sevens 123 Cree S2 Clipless Version
See the New S2 LED Version
Specifications
- Powered by: 1 CR123A battery (included)
- LED Emitter: Premium Cree XP-G R5
- Voltage range: 0.9V ~ 4.2V
- Dimensions
- Length: 3.2 inches
- Diameter: 0.86 inches
- Weight: 1.4 ounces
- 5 Current Regulated Output Levels
- Flash modes: Strobe, SOS, Beacon
- Square threads for lifetime smooth operation
- Type III Hard Anodized finish
- Fully knurled
- Flexible & secure finger grip accessory
- IPX-8 Waterproofing
- Impact-resistant glass lens with Dual-coating - sapphire coating on the outside and anti-reflective coating on the inside for optimal efficiency and durability.
- T-6061 Aircraft-grade Aluminum Body
- Stands on Tail (candle mode)
Typical Output Levels and Runtimes + (LED drive current)
Moonlight: 0.2 lumens for 15 days, (1ma)
Low: 4 OTF lumens for 2.5 days (10ma)
Medium: 22 OTF lumens for 13 hours (50ma)
High: 85 OTF lumens for 2.7 hours (250ma)
Max: 206 OTF lumens for 0.8 hours (700ma)
Strobe: 206 OTF lumens for 1.6 hours
Beacon: 0-206 OTF lumens pulse for 12 hours
Operation
Operating your Quark 123 Clipless is simple. Make sure its batteries are inserted with the positive side (+) toward the head. Ensure the bezel (the 'head' of the light) and tail cap are tightened, then depress the tail cap button fully so that it 'clicks' and the light turns on.
The two most commonly used modes are Max and Moonlight, the highest and lowest modes. To access Max, you simply tighten the bezel. To access Moonlight, you just loosen the bezel a half-turn. That's it.
You can also cycle through the Quark's other modes just as easily. Lightly depress the button momentarily (you don't need to 'click' it off) and the output will switch to the next mode. The mode sequence is determined by whether the bezel is tightened or loosened:
Loosened Bezel: Moonlight - Low - Medium - High - SOS - Beacon
Tightened Bezel: Max - Strobe
Once the Quark has been turned off for at least three seconds, it will revert to the first level of output in the sequence, either Moonlight or Max.